Calculate your result
Enter your figures below. Values stay in your browser.
How to use this calculator
Enter both complete tyre sizes and an indicated speed. The result compares nominal diameters, estimated speed change and ride height. Use the same speed unit when interpreting the input and output.
Formula used
Diameter change % = (new diameter/old diameter − 1) × 100. Estimated actual speed = indicated speed × new diameter/old diameter.
Worked example
Changing 225/45R17 (634.3 mm) to 235/40R18 (645.2 mm) increases nominal diameter by 1.72%. An indicated 60 corresponds to about 61.03 in the same speed unit.
Quantify how a size change affects diameter and indicated speed
Compare complete old and new sizes and enter an indicated speed. The percentage diameter difference gives a quick sense of whether the change is minor or large, while the speed calculation shows the direction of speedometer error.
Nominal diameter is only one fitment check. Suspension clearance, brake clearance, wheel width, offset, load rating and local rules can rule out a size even when the diameter difference looks acceptable.
Assumptions and limits
The speed calculation assumes the old size was the calibration reference. Actual speedometer bias and loaded tyre dimensions are not modelled.
NHTSA: tyre markings and pressure · Calculation methodology
Found a discrepancy? Send the inputs and expected result.
Related tools
Tyre Size Calculator
Decode a tyre size and calculate its dimensions.
Wheel Offset Calculator
Compare wheel inner clearance and outer position.
Tyre Pressure Converter (PSI / Bar)
Convert tyre pressure between PSI and bar, with kPa shown as a cross-check.
This page shows the formula, a worked example, page-specific interpretation and the main limitations so you can audit the result before using it.